Jackiebear1104 Jackiebear1104

02-01-2023
Engineering

Answered

Nozzle-2 inclined at an angle of 30 degree (with horizontal) is added to the system and both water jets strike at some point. for nozzle-2, upon contact, water exit the plate 40% upwards and the remaining downwards. assuming frictionless flow and neglecting gravity effects.

Answer :

Other Questions

Consider an air standard jet engine cycle operating in a 280 k, 100 kpa environment. the compressor requires a shaft power input of 4000 kw. air enters the turb

Steam at 160 bar, 480o c, enters a turbine operating at steady state with a volumetric flow rate of 800 m3 /min. eighteen percent of the entering mass flow exit

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrige

A centrifugal pump is installed in a pipeline between two reservoirs. the pump is required to produce a flow rate of (gallons per minute) in moving water from t

Air enters a compressor operating at steady state at t1 = 320 k, p1= 2 bar with a velocity of 80 m/s. at the exit, t2 = 550 k, p2=10 bar and the velocity is 180

0. 25kg of fluid at a pressure of 3 bar with a specific internal energy and specific volume of 2544KJ/kg and 0. 6057 m^ 3 /kg, respectively, is heated reversibl

For the specifications of problem 6.2.7 suppose that the common-mode and differential-mode currents at the input to the power supply filter at 150 khz are equal

Q1/ a soil sample of diameter of 38 mm and length of 76 mm has a wet weight of 1.6 n and a dry weight of 1.2 n. determine: a- the water content. b- the degree o

Using a paged memory allocation system with a page size of 2,048 bytes and an identical page frame size, and assuming the incoming data file is 20,992, calculat

An unknown immiscible liquid seeps into the bottom of an open oil tank. Some measurements indicate that the depth of the unknown liquid is 1. 5 m and the depth