tayekingtaye1357 tayekingtaye1357

02-01-2023
Engineering

Answered

Steam at 160 bar, 480o c, enters a turbine operating at steady state with a volumetric flow rate of 800 m3 /min. eighteen percent of the entering mass flow exits at 5 bar, 240o c, with a velocity of

Answer :

Other Questions

Air enters a compressor operating at steady state at t1 = 320 k, p1= 2 bar with a velocity of 80 m/s. at the exit, t2 = 550 k, p2=10 bar and the velocity is 180

Consider an air standard jet engine cycle operating in a 280 k, 100 kpa environment. the compressor requires a shaft power input of 4000 kw. air enters the turb

0. 25kg of fluid at a pressure of 3 bar with a specific internal energy and specific volume of 2544KJ/kg and 0. 6057 m^ 3 /kg, respectively, is heated reversibl

A composite plane wall consists of a 5-in. -thick layer of insulation (ks = 0. 029 Btu/h*ft*°R) and a 0. 75-in. -thick layer of siding (ks = 0. 058 Btu/h*ft*°R)

An 8cm diameter hydraulic cylinder ha 4cm diameter rod if the cylinder receive flow of 100lpm and 12mpa

If 20,000 CFM of air at the condition in Q8 is cooled to the condition with dry-bulb temperature of 55°F and wet-bulb temperature of 55°F,What is the rate of se

A circuit has three resistors connected in series. resistor r2 has a resistance of 220 ohms and voltage drop of 44 v. what is the current flow through resistor

A shunt DC motor rated at 230 V, with armature resistance of 0.05 22 and field resistance of 75 12, consumes 7 A when no-load at 1120 rpm. The current consumed

A paper mill processes rolls of paper having a density of 984 kg/m3. the paper roll is 1.50-m outside dia. (od) x 0.22-m inside diameter (id) x 3.23-m long and

propeller of diameter D rotates at angular velocity in a liquid of density and viscosity . The required torque T is determined to be a function of D, , , and .