amandineclaude1587 amandineclaude1587

02-01-2023
Engineering

Answered

A baseball is thrown by a pitcher at 95 mph through standard air. the diameter of the baseball is 2.82in. estimate the drag force on the baseball. state any assumptions.

Answer :

Other Questions

Consider an air standard jet engine cycle operating in a 280 k, 100 kpa environment. the compressor requires a shaft power input of 4000 kw. air enters the turb

An 8cm diameter hydraulic cylinder ha 4cm diameter rod if the cylinder receive flow of 100lpm and 12mpa

A hydraulic accumulator is charged with an air preload of 1,000 psi. when a hydraulic system pressure of 3,000 psi is developed, the pressure on the air side of

Determine the force in members BC, CH, GH, and CG of the truss and state if the memt truss and state if the members are in tension or compression.

propeller of diameter D rotates at angular velocity in a liquid of density and viscosity . The required torque T is determined to be a function of D, , , and .

the two arms of the l-shaped handle on the spigot of (figure 1) have a length ratio of 1:3√. At what angle theta do you want to pull down on the end of the hand

A composite plane wall consists of a 5-in. -thick layer of insulation (ks = 0. 029 Btu/h*ft*°R) and a 0. 75-in. -thick layer of siding (ks = 0. 058 Btu/h*ft*°R)

If 20,000 CFM of air at the condition in Q8 is cooled to the condition with dry-bulb temperature of 55°F and wet-bulb temperature of 55°F,What is the rate of se

The circuit above has already been converted into impedance form. Calculate the phasor of the current through the middle branch with the given polarity. Put you

An engineer is designing a device to measure how the density of seawater changes with depth. The device consists of a hollow spherical metal container of known