kayli7205 kayli7205

27-12-2022
Engineering

Answered

m142.0 bolts and nuts clamp a 16-mm-thick aluminum cover plate to a 12-mm-thick steel flange. determine the stiffness factor of the joint at each bolt.

Answer :

Other Questions

Consider the curb shown in (Figure 1). Suppose that 1 = 2 m, a = 180 mm, b = 100 mm. Part A Determine the volume of concrete needed to construct the curb. Expre

Compute the elastic modulus for the following metal alloys, whose stress-strain behaviors may be observed in the "Tensile Tests" module of Virtual Materials Sci

The pendulum consists of two slender rods AB and OC which have a mass of 3 kg / m. The thin plate has a mass of 12 kg / m2. Determine the location y- of the cen

the horizontal sections of a steel frame are the . a. shell c. suspension b. i-beams d. rebar please select the best answer from the choices provided a b

Determine (a) the principal stresses and (b) the maximum in-plane shear stress and average normal stress at the point. Specify the orientation of the element in

6.5 Determine the vorticity field for the following velocity vector: V=(x^2-y^2)i -2xyj

an industrial plant load is rated at 2.8 mva at 0.7 pf lagging. if a capacitor bank rated at 3 mva is added to the load, the new overall power factor of the sys

Air flows through a pipe at a rate of 200 L/s. The pipe consists of two sections of diameters 20 cm and 10 cm with a smooth reducing section that connects them

F9-1. Determine the centroid (x y) of the shaded area. 1 m 1 m Prob. F9-1

Determine the force in member AB of the truss and state if the member is in tension or compression. Hint: The vertical component of force at C must equal zero.