rouaamakki5256 rouaamakki5256

27-12-2022
Engineering

Answered

The pendulum consists of two slender rods AB and OC which have a mass of 3 kg / m. The thin plate has a mass of 12 kg / m2. Determine the location y- of the center of mass G of the pendulum, then calculate the moment of inertia of the pendulum about an axis perpendicular to the page and passing through G.

Answer :

Other Questions

A plastic coating is applied to wood panel by first depositing molten polymer on a panel and then cooling the surface of the polymer by subjecting it to air flo

Q4 A heat engine has a heat input of 3 X 104 Btu/h and a thermal efficiency of 40 percent. Calculate the power it will produce, in hp. Source 3 x 10+ Btu/h 7th

3.47 A crane is oriented so that the end of the 25-m boom AO lies in the yz plane. At the instant shown, the tension in cable AB is 4 kN Determine the moment ab

Before the trunk of a large tree is felled, cables AB and BC are attached as shown. Knowing that the tensions in cables AB and BC are 625 N and 730 N, respectiv

Chilled water enters a thin-shelled 5-cm-diameter, 150-m long pipe at 7°C at a rate of 0.98 kg/s and leaves at 8°C. The pipe is exposed to ambient air at 30°C w

A dormitory at a large university, built 50 years ago, has exterior walls constructed of L5 = 25-mm-thick sheathing with a thermal conductivity of k3 = 0. 1 W/m

Determine the equivalent resultant couple moment about point O. Enter the x, y, and z components of the moment separated by commas using three significant figur

: A uniform slender rod AB rests on a frictionless horizontal surface, and a force P of magnitude 0.25 lb is applied at A in a direction perpendicular to the ro

lace the force system by a wrench and specif 4-135. Replace the for nitude of the force and couple moment of the wrench oint where the wrench intersects the x-z

Determine the maximum tensile and compressive bending stress in the beam if it is subjected to a moment of M=4 kip. ft