nans9067 nans9067

05-11-2022
Physics

Answered

A vernier caliper of least count 0.1mm is used to measure the length of tube.
The length of tube is found to be 5cm long. How should this measurement
be recorded in a table of results?

Answer :

Other Questions

The toy car in Figure 20 runs off the edge of a table that is 1.225m high. The car lands 0.4000m from the base of the table. Show all work. How long did it take

n 1831, Michael Faraday was the first to realize that an electric current could be induced by passing a magnet through a coil of copper wire. Which factor is M

FIGURE 3 shows a uniform rod of length 1.80 m and mass 9 kg resting on support at point X. Weight of the object A is 60 N is put on the end of the rod. If the t

FIGURE 3 shows a uniform rod of length 1.80 m and mass 9 kg resting on support at point X. Weight of the object A is 60 N is put on the end of the rod. (a) If t

Part D What are the strengths and limitations of the model? BIUX² X₂ 15px AV Characters used: 0/15000 SIC V A EEEEEE Submit

Along with force, which other variable is used to calculate impulse?(1 point) A The mass of an object. B The amount of time the object is in motion. C The amoun

1. A 5.0-kg bowling ball experiences a net force of 11.0 N. What will be its acceleration? 2. An astronaut applies a force of 650 N to an asteroid, and it acce

To review the concept of conservative forces and to understand that electrostatic forces are, in fact, conservative. As you may recall from mechanics, some forc

An object is launched with an initial velocity of 25.0 meters per second at an angle of 30° above horizontal. a. Determine the components of the initial veloci

Which of the following is an expression for mechanical power ? A.Fm/t B.F^2m/a C.Fm^2/t D.F^2t/m E.Ft/m In the sample paper it says f2t/m