yasithsandaruwan29 yasithsandaruwan29

19-08-2022
Physics

Answered

Why backward curve fan has a non overloading characteristic?

Answer :

adioabiola adioabiola

30-08-2022

Backward curve fan has a non overloading characteristic simply because the pressing changes in static pressure do not overload the motor.

What is centrifugal fan?

A centrifugal fan means a kind of a mechanical device for moving air or other gases in a direction at an angle to the incoming fluid

A centrifugal fan has some key characteristics such as low noise level and small air flow with a high increase in static pressure

So therefore, backward curve fan has a non overloading characteristic simply because the pressing changes in static pressure do not overload the motor.

Learn more about centrifugal fan:

https://brainly.com/question/14279841

#SPJ1

Answer Link

Other Questions

An AC circuit consists of a non-ideal source, an ideal transformer, and a load impedance. Assume VTH = 66/42° VRMS, ZTH = 86/-37° and n = 2. Zih 1:n + th ele ll

Why do we think that Venus has so much more atmospheric gas than Earth? Most of the gases that have been released from volcanoes on Earth later returned to the

when a loop repeats until a variable has a specific value, that value is referred to as the value.

In this figure, why is the kinetic energy gained by the falling ball equal to the change of potential energy? (Assuming no loss of energy due to friction.)

A square meter of the axon membrane has a resistance of 0.2 ohms. The membrane is 7.5 x 10‐⁹ m thick. What is the resistivity of the membrane?

Keisha writes that if an object has any external forces acting on it, then the object can be in dynamic equilibrium but not static equilibrium.

and it is corrupted by additive white gaussian noise, n(t) that has power spectral density (psd) of n0/2 w/hz. the frequency response of the ideal low pass filt

5. a particular satellite with a mass of 200kg is put into orbit around ganymede (the largest moon of jupiter) at a distance 300 km from the surface. what is th

A student wants to increase the temperature of an ideal gas in a cylinder that is initially at room temperature. The cylinder has a movable piston with negligib

Figure 30-44a shows a wire that forms a rectangle (W ! 20 cm, H ! 30 cm) and has a resistance of 5.0 m . Its interior is split into three equal areas, with magn