III.
Direction: Arrange the following steps on splicing of wires in proper sequence. Write A for the first step, B for
second step, C for third step and D for fourth step. Write your answer on another sheet of paper.
SET A.
Steps in splicing western union long-the joint
Figures
Steps
1. Wrap each side of the wire for about four to five
turns as shown in figure.
2. Make four to six long twists of wires.
3. Place the wires in crossed position about mid
halfway from the insulation.
4. Strip the wire ends for about 75 mm.
SET B.
1. Turn the tap wire around the main wire making
four to five turns.
Steps in splicing aerial tap joint
2. Bend the tap wire over the main wire making a
long twist.
3. Place the wires in crossed position intersecting
about 5 mm from the insulation of the tap wire and
the main wire.
مطلب
4. Strip the tap wire end about 75 mm. and the main
wire end about 25 mm.
9