bobby74781 bobby74781

02-01-2023
Engineering

Answered

Two hvac/r technicians are discussing the use of hand tools. technician a says that when you're tightening the nuts and bolts on a compressor head, it's important to use the same amount of force on each nut and bolt to prevent the head from warping. technician b says that a pipe should be securely clamped in a flaring block before the ending is flared. which one of the following statements is correct?

Answer :

Other Questions

Technician a says a drum micrometer is used to measure the inside diameter of a brake drum. technician b says it only measures metric drums. who is correct

Technician a says that when fuel is being dosed to a dpf, the unit is being passively regenerated. technician b says that when fuel is being dosed to a dpf, the

Technician A says that the basecoat may be applied directly over a self-etching primer. Technician B says that the acid in self-etching primer neutralizes as it

Air enters a compressor operating at steady state at t1 = 320 k, p1= 2 bar with a velocity of 80 m/s. at the exit, t2 = 550 k, p2=10 bar and the velocity is 180

What did 15-year-old jack invent? why? what was the most important lesson the teams learned when participating in the extreme by design projects? what tools did

Tech A says that when performing a cylinder leakage test, the piston should be positioned at bottom dead center. Tech B says that a blown head gasket would gene

Tech A says that when governor pressure on one side of a shift valve overcomes spring pressure and throttle pressure on the other side, an upshift occurs. Tech

Select the correct answer from each drop down menu. A rod measures 6. 12 +0. 2. In this expression, what does each of the figures indicate? In the measurement,

What are the two types of safeties found in modern shotguns? drop and pivot bolt and lever manual and grip crossbolt and tang?

Tech a says that can c typically uses two 120-ohm terminating resistors with a total circuit resistance of 60 ohms. tech b says that can c uses two 120-ohm term