firaolnegn firaolnegn

28-12-2022
Engineering

Answered

A refrigerator with refrigerant-134a as the working fluid is used to keep the refrigerated space at -30 oC by rejecting its waste heat to cooling water that enters the condenser at 18 oC at a rate of 0.25 kg/s and leaves at 26oC. The refrigerant enters the condenser at 1.2 MPa and 65oC and leaves at 42oC. The inlet state of the compressor is 60 kPa and -34oC and the compressor is estimated to gain a net heat of 450 W from the surroundings. Determinea) the quality of the refrigerant at the evaporator inlet
b) the refrigeration load,
c) the COP of the refrigerator, and
d) The theoretical maximum refrigeration load for the same power input to the
compressor.

Answer :

Other Questions

which nec article permits the disconnect switch for a large rooftop air conditioner to be mounted inside the unit?Step-by-step solution Step 1 of 1 The compress

an industrial plant load is rated at 2.8 mva at 0.7 pf lagging. if a capacitor bank rated at 3 mva is added to the load, the new overall power factor of the sys

Air flows through a pipe at a rate of 200 L/s. The pipe consists of two sections of diameters 20 cm and 10 cm with a smooth reducing section that connects them

Troy must keep track of the amount of refrigerant he uses from a 50 pound cylinder to ensure that accurate records are kept he used 13 pounds on a system for ms

Naturally found uranium consists of 99.274%, 238U, 0.720%235U, and 0.006% 233U (by mass). As we have seen, 235U is the isotope that can undergo a nuclear chain

Propane gas (C3H8) at 25C, 1 atm enters an insulated reactor operating at steady state and burns completely with air entering at 25C, 1atm. Plot the adiabatic f

a motor compressor unit with a rating of 32 amps is protected from over loads by a separate overload relay selected to trip at not more than amps.

The pressure at the second floor faucet in the residential building is 45 psi, which is less than the recommended domestic pressure range of 50 to 60 psi. It is

Determine (a) the principal stresses and (b) the maximum in-plane shear stress and average normal stress at the point. Specify the orientation of the element in

Part A Determine the force in members CD of the truss, and state if the member is in tension or compression. Take P = 1570lb FCD = Part B Determine the force in