imclueles3998 imclueles3998

23-12-2022
Engineering

Answered

Consider the truss shown in (Figure 1). Suppose that F = 11 kN .Part A:Determine the force in member BC of the truss and state if the member is in tension or compression.Express your answer to three significant figures and include the appropriate units. Enter negative value in the case of compression and positive value in the case of tension.

Answer :

Other Questions

find the following, assuming the truss does not deform out-of-plane: (a) the reaction forces at the supports. (b) the forces carried in each member. (c) the min

given the following data points, what is the compression rate? size of input: 1,000 size of output: 700 enter your answer as a whole number.

determine the horizontal and vertical components of force at pins a and c of the two-member frame.

Find the values of the unspecified quantities (shown in red) in Figure shown.

determine the angle θ between the y axis of the pole and the wire ab.(figure 1)

After the switch in the circuit of Fig. P 7.35 has been open for a long time, it is closed at t=0. Calculate (a) the initial value of i; (b) the final value of

Project 9: RandomNumberGuesser - Write in JAVA - Make sure it works on REPLIT.COM The goal this week is to experiment with one of the main benefits of OOP: Exte

The bottom hole in the dam is blocked by a flat rectangular shield with a width of -6 m. The water depth in the upstream h1 = 23 m, the depth in the downstream

determine and its region of convergence. (b) determine (c) if keep the same system, but change the input , determine the output . h(t) x(t) h(s) y(t) , 2 2 ( )

consider the velocity field v={−4yti+2xtj}m/s for the following parts.