vritxii1486 vritxii1486

23-12-2022
Engineering

Answered

Which method is used by a PAT-enabled router to send incoming packets to the correct inside hosts? It uses the source TCP or UDP port number on the incoming packet. It uses a combination of the source TCP or UDP port number and the destination IP address on the incoming packet. It uses the destination TCP or UDP port number on the incoming packet. It uses the source IP address on the incoming packet

Answer :

Other Questions

NAT has been configured to translate source addresses of packets for the inside part of the network, but only for some hosts as identified by an access control

Based on the following configuration, what would be the assigned global unicast address ? interface fastEthernet 0/0 mac-address 0200.8395.2614 ipv6 address 250

Project 9: RandomNumberGuesser - Write in JAVA - Make sure it works on REPLIT.COM The goal this week is to experiment with one of the main benefits of OOP: Exte

a crane with a 100-ft boom is being used to set a small load on the roof of the building shown. the minimum standoff (point a) from the corner of the building t

The ______ must be placed on timbers or cribbed so as to spread the weight of the crane and the load over a large enough area.

Water enters a 200 L tank at a rate of 10 g/s and is withdrawn at a rate of 10 g/s. The tank is initially half full – Draw and label process streams and flows –

Water enters a 200 L tank at a rate of 10 g/s and is withdrawn at a rate of 10 g/s. The tank is initially half full – Draw and label process streams and flows –

The bottom hole in the dam is blocked by a flat rectangular shield with a width of -6 m. The water depth in the upstream h1 = 23 m, the depth in the downstream

perform the dynamic analysis (you only need to write the equations of equilibrium. there is no requirement to solve the equations). from the dynamic analysis th

the 2-lb brick slides down a smooth roof, such that when it is at a it has a velocity of 5 ft/s.