cutpet101 cutpet101

22-12-2022
Engineering

Answered

The bottom hole in the dam is blocked by a flat rectangular shield with a width of -6 m. The water depth in the upstream h1 = 23 m, the depth in the downstream h2 = 11.5 m, the height of the bottom hole t = 17.25 m, the angle of inclination a = 40 °. The sewing can rotate around the axis, which is projected to point A. Determine the force T required to raise the shield.

The bottom hole in the dam is blocked by a flat rectangular shield with a width of 6 m The water depth in the upstream h1 23 m the depth in the downstream h2 11 class=

Answer :

Other Questions

Calculate the normal depth in the following canal sections to convey a discharge of 10m3 /s. The Manning’s coefficient, n for all type sections is 0.012 and so=

a crane with a 100-ft boom is being used to set a small load on the roof of the building shown. the minimum standoff (point a) from the corner of the building t

A British Thermal Unit (BTU) is defined as the amount of energy required to raise the temperature of one pound of water by one degree Fahrenheit. Your family ha

The cutting force and thrust force have been measured in an orthogonal cutting operation to be 300 lb and 291 lb, respectively. The rake angle = 10°, width of c

The bath tub vortex hown in gure(4) conit of a rotational region (rigid body motion) up to a radiu of r = 0. 6 meter where the tangential velocity of uid under

consider a 30 centim leter diameter pan filled with water at 15c located in a room. the room 1s at 20 c, 101 kp, and 30 percent relative humidity. ignore heat t

Consider the Cyclic Redundancy Check (CRC) algorithm discussed in Section 6.2.3 of the text. Suppose that the 4-bit generator (G) is 1001, that the data payload

find the following, assuming the truss does not deform out-of-plane: (a) the reaction forces at the supports. (b) the forces carried in each member. (c) the min

Write the recurrence formula for the TIME COMPLEXITY of this function, including the base cases for N>=0. (You do NOT need to solve it.) (Note that it should

raw sugar cane is taken into a process to create sugar, which is essentially sucrose. the raw cane is approximately 16% sucrose, 63% water, and the rest fiber b