lroland234 lroland234

21-12-2022
Engineering

Answered

What would be the proper dimensions for a hot water storage tank for a factory having 24 workers, assuming a per capita demand of 20 gallons per 24 hours and a peak demand at the rate of 95 gallons per hour?

Answer :

Other Questions

An air conditioner in a climate with average humidity will collect about ______ of condensate per hour of operation for each ton of air-conditioning.A. 1 quartB

Water enters a 200 L tank at a rate of 10 g/s and is withdrawn at a rate of 10 g/s. The tank is initially half full – Draw and label process streams and flows –

Water enters a 200 L tank at a rate of 10 g/s and is withdrawn at a rate of 10 g/s. The tank is initially half full – Draw and label process streams and flows –

find the following, assuming the truss does not deform out-of-plane: (a) the reaction forces at the supports. (b) the forces carried in each member. (c) the min

consider a 30 centim leter diameter pan filled with water at 15c located in a room. the room 1s at 20 c, 101 kp, and 30 percent relative humidity. ignore heat t

A British Thermal Unit (BTU) is defined as the amount of energy required to raise the temperature of one pound of water by one degree Fahrenheit. Your family ha

y Estimating output from a turbine: the following data for a large turbine designed for high-wind areas is provided. The turbine swept area has a diameter of 80

Write the recurrence formula for the TIME COMPLEXITY of this function, including the base cases for N>=0. (You do NOT need to solve it.) (Note that it should

1). An electronic PID temperature controller is at steady state with an output of 10 mA. The set point equals the initial steady-state process temperature. At t

An airplane flies at a speed of 400 mph at an altitude of 10,000 ft. If the boundary layers on the wing surfaces behave as those on a flat plate, find the exten