bluepiggy3554 bluepiggy3554

21-12-2022
Engineering

Answered

a crane with a 100-ft boom is being used to set a small load on the roof of the building shown. the minimum standoff (point a) from the corner of the building to the centerline of the boom is indicated. what is the maximum distance (ft) from the edge of the building that the load can be placed on the roof?

Answer :

Other Questions

Service cable mounted in contact with a building must be supported at intervals not exceeding _____. a) 4 ft. b) 3 ft. c) 30 in. d) 24 in. 230.51(A).

a farm has three buildings with loads of 82a, 65a and 15a. what is the total load? assume that there are no dwellings or motors.

An airplane flies at a speed of 400 mph at an altitude of 10,000 ft. If the boundary layers on the wing surfaces behave as those on a flat plate, find the exten

The post is made from 6061-T6 aluminum and has a diameter of 50 mm. It is fixed supported at A and B, and at its center C there is a coiled spring attached to t

Consider the Cyclic Redundancy Check (CRC) algorithm discussed in Section 6.2.3 of the text. Suppose that the 4-bit generator (G) is 1001, that the data payload

Write the recurrence formula for the TIME COMPLEXITY of this function, including the base cases for N>=0. (You do NOT need to solve it.) (Note that it should

find the following, assuming the truss does not deform out-of-plane: (a) the reaction forces at the supports. (b) the forces carried in each member. (c) the min

y Estimating output from a turbine: the following data for a large turbine designed for high-wind areas is provided. The turbine swept area has a diameter of 80

The bath tub vortex hown in gure(4) conit of a rotational region (rigid body motion) up to a radiu of r = 0. 6 meter where the tangential velocity of uid under

raw sugar cane is taken into a process to create sugar, which is essentially sucrose. the raw cane is approximately 16% sucrose, 63% water, and the rest fiber b