Jabari4458 Jabari4458

20-12-2022
Engineering

Answered

A British Thermal Unit (BTU) is defined as the amount of energy required to raise the temperature of one pound of water by one degree Fahrenheit. Your family has a water heater that is rated for 30,000 BTUs and has a capacity of 500 pounds of water. What is the expected change in temperature of the water?a. 140 Fb. 120 Fc. 90 Fd. 60 Fe. 30 F

Answer :

Other Questions

Dicu water retention in oil in relation to availability of oil water to crop growth

What is the attenuation in db for a 4th order low pass filter at a frequency of 10fc, where fc is the filter's corner frequency?

what type of energy is due to the position of an object? select the correct answer below: kinetic energy potential energy motion energy mechanical energy

Water enters a 200 L tank at a rate of 10 g/s and is withdrawn at a rate of 10 g/s. The tank is initially half full – Draw and label process streams and flows –

Water enters a 200 L tank at a rate of 10 g/s and is withdrawn at a rate of 10 g/s. The tank is initially half full – Draw and label process streams and flows –

y Estimating output from a turbine: the following data for a large turbine designed for high-wind areas is provided. The turbine swept area has a diameter of 80

Consider the Cyclic Redundancy Check (CRC) algorithm discussed in Section 6.2.3 of the text. Suppose that the 4-bit generator (G) is 1001, that the data payload

The bath tub vortex hown in gure(4) conit of a rotational region (rigid body motion) up to a radiu of r = 0. 6 meter where the tangential velocity of uid under

1). An electronic PID temperature controller is at steady state with an output of 10 mA. The set point equals the initial steady-state process temperature. At t

Suppose you are given a set of jobs J1, ..., Jm to perform. Each job Ji will pay you some amount of money Pi (not all jobs give the same payment). Each job J; a