pbbyrom08 pbbyrom08

15-11-2022
Physics

Answered

Examine the diagram of the electromagnetic spectrum below.

Diagram of electromagnetic spectrum. Gamma waves have wavelengths of approximately 10 to the power of negative 12 meters. x-rays have wavelengths of approximately 10 to the power of 10 meters. Microwaves have wavelengths of approximately 10 to the power of negative 2 meters. Radio rays have wavelengths of approximately 10 to the power of 3 meters.

If a wave has a wavelength of 0.1 nanometer, it must be a(n)

gamma ray
microwave
radio wave
x-ray

Answer :

Other Questions

- Parallel dc Circuits : - For the parallel network shown: a. Find the total resistance (RT). b. Determine the source current and the current through each bran

- For the following parallel circuit: a) Find the total current Is, I1, and I2. b) Verify that Kirchhoff’s current law (KCL) applies to the circuit. c) Find the

A 1275 kg car travels 10 meters in 40 seconds. What is the car’s power?

A 1.0 kg block is pushed 3.0 m at a constant velocity up a vertical wall by a constant force applied at an angle of 28.0 ◦ with the horizontal, as shown in the

What force is being applied to the boy and cart if the boy and cart have a mass of 120kg and the spring is compressed 1.2 meters. The spring's constant is 6.5x1

As part of an experiment on Mythbusters, a car was dropped from a crane 131 m (approximately 430 ft) above the ground. If you assume there is no air resistance,

For this assignment, you will: ● ● Read the passage (below) from your textbook. Think about the main ideas contained in the passage. Make a list of four (4) mai

The graphs below model the speed of a car. Use terms from the word bank to describe what is happening to the car's acceleration. Assume the speed (m/s) and time

An object of height 5.0 mm is placed 35.0 cm from the vertex of a spherical surface of a glass rod. An image is formed inside the rod 50.0 cm from the vertex of

What are some ways to change the resistance in a circuit? Suppose you have an electrical device that needs a steady current of 10 milliamperes. You need to grea