shawny7429 shawny7429

04-11-2022
Chemistry

Answered

when performing gel electrophoresis, why did we use a buffer in the chamber? why not just use water?

Answer :

Other Questions

recall that your chambers had a set amount of co2 entering each chamber and then you measured how much co2 was exiting the chamber. suppose you conducted your e

during the reflux, the reaction flask was heated in a sand bath. why did you use sand and not water bath to heat the flask?

suppose you are given solutions of 1.00 m acetic acid and 1.00 m sodium acetate and are asked to make 100.00 ml of buffer at ph 5.00 using only these two soluti

discuss the effect of this leftover water in the cuvettes in two cases: a) water remains in the cuvette a standard solution is poured in; b) water remains in th

Hari plays violin in her school's orchestra. the violin is a stringed instrument. some of the other stringed instruments in the orchestra are the viola, the bas

On the basis of the data, the best prediction of the ph of the water in which daphnia normally are found in the wild is?.

At the same pressure, about 20 times more co2 will dissolve in plasma as o2. Why does this occur?.

a student started with 1.453 grams of copper (ii) oxide and produced 3.500 g of copper (ii) sulfate. what is the percent yield? the product is a hydrate. use ap

why do the strengths of london (dispersion) forces generally increase with increasing molecular size?

assume that you started with anisole, and the product you should have gotten was tribromoanisole. however your recrystallization technique was poor and you did