itslogan3829 itslogan3829
  • 04-11-2022
  • Physics
Answered

when a grinding operation is performed with a spindle speed of 4000 rpm, a wheel diameter of 250 mm, a depth of cut of 0.0375 mm, and a feed rate of 16 m/min, heat checking is found to occur. if a new 200-mm-diameter wheel is used, what spindle speed should be employed in order to avoid heat checking? what spindle speed should be used to maintain the



Answer :

Other Questions

1.0 * 1020 electrons flow through a cross section of a 2.0-mm- diameter iron wire in 5.0 s. what is the electron drift speed?
A family went on a sea tour in Beirut . If the boy Haywa runs to the back of the boat at a speed of 3.5 m/s while the speed of the boat is 18 m/s , what would H
measuring the speed of light: michelson in 1926, albert michelson measured the speed of light with a technique similar to that used by fizeau. michelson used an
a simple harmonic oscillator has an amplitude of 3.50 cm and a maximum speed of 26.0 cm/s. what is its speed when the displacement is 1.75 cm?
blood is pumped from the heart at a rate of 5.0 l/min into the aorta (of radius 1.0 cm). determine the speed of blood through the aorta.
an air-filled capacitor is made from two flat parallel plates 1.0 mm apart. the inside area of each plate is 8.0 cm2. (a) what is the capacitance of this set of