santacartel4849 santacartel4849

27-10-2022
Physics

Answered

1. the capacitor in the figure below is initially uncharged and the switch, in position c, is not connected to either side of the circuit. the switch is now flipped to position a for 10 ms, then to position b for 10 ms, and then brought back to position c. what is the final potential difference across the capacitor?

Answer :

Other Questions

a capacitor and a resistor are connected in parallel to a 120-v, 60-hz line. the resistor has a resistance of 40 , and the capacitor has a capacitance of 132.6

a 2 kg mass hangs from a vertical spring. you pull down on the mass and thrust it vertically downward at 2 m/s. it goes down and then bounces back up again. wha

The two lines on the position-time graph describes the motion of two different objects. By what distance (in m) are the two objects separated at a time of 5.0 s

you throw a 0.53-kgkg target upward at 15 m/sm/s. when it is at a height of 10 mm above the launch position and moving downward, it is struck by a 0.318-kgkg ar

a ceiling fan is turned on and reaches an angular speed of 120 rev/min in 20 s. it is then turned off and coasts to a stop in an additional 40 s. what is the ra

A resistor with a potential difference of 15.0 V develops a heat output of 327 W. a) What is its resistance? b) What is the current across the resistor?

a 0.20-kg object is traveling to the right (in the positive direction) with a speed of 3.0 m/s. after a 0.20 s collision, the object is traveling to the left at

a car is traveling to the right at constant speed along a flat, horizontal road. a small pebble stuck on the outside of one of the tires is located above and to