tiffanypartida6 tiffanypartida6

26-10-2022
Chemistry

Answered

If the initial reading is 2.50 mL, and the final reading is 26.00 mL, then the amount of titrant used is:
Follow significant figure rules. In this case, 2 places after the decimal point.

Answer :

Other Questions

Write the number of Significant figures (1) 0.0000055 2 1.6402 g (3) 3.40 x 103 mL (4a) 1.020 L 4) 0.500 5) 500 5.9x 104 0.40001 1.7x 10-3 9) 650_ 10) 4.150 x 1

Write the number of Significant figures (1) 0.0000055 2 1.6402 g (3) 3.40 x 103 mL (4a) 1.020 L 4) 0.500 5) 500 5.9x 104 0.40001 1.7x 10-3 9) 650_ 10) 4.150 x 1

A rock is placed in a graduated cylinder. The water level rises from 5 mL to 25 mL; therefore the displacement is 20 mL. The mass of the rock prior to being sub

4. A student standardized a NaOH solution and obtained the following data: Mass of KHP = 0.4755 g End Volume = 25.10 mL Initial Volume = 0.00 mL Calculate the f

. Place a weigh boat on the digital scale and press the button on the right-hand side (0/T). Your scale should read 0.0 g.2. Use your metal spatula to weigh out

Determine the mass (in g) of hydrated CuSO4 necessary to make 100 mL of a 0.150 M solution. The molar mass is equal to 249.72 g/mol.

Which of these is difference between measurements of solids and liquids? A A solid's density can change, while a liquid's density cannot. B the same, the densit

3. A metal is poured into a graduated cylinder that holds exactly 49 ml. The metal used to fill the cylinder weighs 108 g. From this information, calculate the

The partial pressure of water vapor in saturated air at 35.0°C is 42.2 torr. How many water molecules are present in each mL of saturated air at this temperatur

Using molarity to find solute mass and solution A chemist adds 390.0 mL of a 1.5M aluminum chloride (AICI3) solution to a reaction flask. Calculate the mass in