cuebert3803 cuebert3803

18-10-2022
Physics

Answered

chegg a transverse wave with a frequency of 877 hz ,4 m wavelength, and 10 mm amplitude is propagating on a 3 m, taught wire. if the mass of the wire is 59 g, how much time in seconds does it take for a crest of this wave to travel the length of the wire? please give your answer with two decimal places.

Answer :

Other Questions

1. The copper wire used has a diameter of 0.24 mm. What is its cross-sectional area in mm2 ? What is this in m2? 2. A load of 10 N is applied to the wire. What

Extension questions: 5. Suppose this sample of wire was replaced with one of half the diameter. What would be the new value of the stress? 6. What extension wou

The distance a wave travels during one cycle is called its. This is usually measured as the distance between two or two troughs.

In the wavelength and photosynthesis experiment, what is the purpose of the beaker left in the dark?.

The circuit is protected by a ground fault interrupter in the plug. The water in the tank is grounded. The two bare wires correspond to the two pins on the grou

. a generator uses a coil that has 95 turns and a 0.750-t magnetic field. the frequency of this generator is 60.0 hz, and its emf has an rms value of 110 v

acceleration is the time derivative of velocity. because velocity is a vector, it can change in two ways: the length (magnitude) can change and/or the direction